CRANK TRIGGER
GAP .100 - .125 (SLOWER CRANKING CARS MAY NEED CLOSER)
TEST APROX. 40 OHMS PIN TO PIN
OPEN PIN TO SENSOR CASE
STATIC RETARD NOT ENABLED = LEAD MAGNET 1 DEGREE
RETARD ENABLED = LEAD 2 DEGREES PLUS CHIP VALUE
GROUND CONNECT BLACK GROUND LEAD TO CHASSIS OR ENGINE
BRACKET RCD ENGINEERING BRACKET WORKS PERFECT
THANKS
DAVE LEAHY
NTO:
Best to ohm check pickup mounted on car in the bracket.
Do not over tighten bracket screw. This may oval tubing and short pickup.
Run cables so to minimize vibration and strain.
Pickup must have clearance from blower pulley.
Keep all connectors and ground wires clean and dry. ( no connector grease! )
Replace and/or inspect connectors
on pickups, gen, and gray cables often.